Document Feedback - Review and Comment
Step 1 of 4: Comment on Document
How to make a comment?
1. Use this to open a comment box for your chosen Section, Part, Heading or clause.
2. Type your feedback into the comments box and then click "save comment" button located in the lower-right of the comment box.
3. Do not open more than one comment box at the same time.
4. When you have finished making comments proceed to the next stage by clicking on the "Continue to Step 2" button at the very bottom of this page.
Important Information
During the comment process you are connected to a database. Like internet banking, the session that connects you to the database may time-out due to inactivity. If you do not have JavaScript running you will recieve a message to advise you of the length of time before the time-out. If you have JavaScript enabled, the time-out is lengthy and should not cause difficulty, however you should note the following tips to avoid losing your comments or corrupting your entries:
-
DO NOT jump between web pages/applications while logging comments.
-
DO NOT log comments for more than one document at a time. Complete and submit all comments for one document before commenting on another.
-
DO NOT leave your submission half way through. If you need to take a break, submit your current set of comments. The system will email you a copy of your comments so you can identify where you were up to and add to them later.
-
DO NOT exit from the interface until you have completed all three stages of the submission process.
(1) Refer to the definitions section of the Fraud and Corruption Control Policy for the defintions of fraud and corruption. (2) Public interest disclosures under the Public Interest Disclosures Act 2012 are allegations of improper conduct or detrimental action by a current or former RMIT employee or Council member. These cannot be investigated by RMIT and must be reported to the Victorian Independent Broad-based Anti-Corruption Commission (IBAC). (4) Detrimental action is a reprisal against someone who makes a public interest or whistleblower disclosure. It includes intimation, harassment, discrimination or disadvantaging them in relation to their employment or career. (5) Employees can seek advice from Central Complaints and Investigations (investigations@rmit.edu.au) or the Whistleblower Coordinator (whistleblower@rmit.edu.au) if they are uncertain about whether to disclose suspected fraud or corruption to RMIT or to an external body. (6) The following table lists examples of high-risk areas for fraudulent or corrupt conduct.Fraud and Corruption Control Policy Schedule 1 - Examples of Corruption, Fraud, Public Interest Disclosures and High Risk Areas
Fraud and Corruption
Public Interest Disclosures
High risk areas